Skip to main content
Hi

Following on from my last post on the difference between CoM and CoG is this presentation looking at Centre of Mass, Centre of Pressure and Centre of Force, The Three C's.

I think that these three are in many ways very similar in concept and do well to be understood and studied together.

Here is the 1st Part Centre of Mass I think you'll find this more relevant to Podiatric Biomechanics that perhaps the previous blogs have been. Enjoy!

Comments

Post a Comment

Popular posts from this blog

Torque Moments Levers

Torque, Moments, Axis and Levers - now this is the meat of podiatric biomechanics. Torque and moment are used to describe rotational force, i.e. force applied to a lever about some axis of rotation. Moment is the more usual term in biomechanics and moments of force are in the units of Newton.meters Nm. Why? because Newton is the basic unit of force and metre is the measure of the length of the lever. So the unit of mass is kilogram and gravity (on earth) acting on 1kg is equal to 9.87Newtons, why? Because as we've seen before the acceleration of gravity is 9.87m/s^2 and if you remember Force = Mass x Acceleration (f=ma) Example: a lever 500mm long with a force applied of 250N results in a moment of 125Nm Simple enough of course. There are classically 3 types of lever, 1) force-fulcrum-load, 2) Force-load-fulcrum 3) Load-force fulcrum and they can all be seen in the body (https://www.slideshare.net/spanglerscience/muscle-leversppt-presentation  Although a lever is a ...
5 comments
Read more

Three Cs Part Two - Centre of Pressure and Centre of Force

Two very important concepts to understand in biomechanics are Centre of Pressure and Centre of Force. These are often used interchangeably but are actually different, mostly though, by convention, it is CoP that is used when considering how normal forces act over an area. Normal force means that force perpendicular to the surface of interest. When 2 objects act on each other with force then there will always be an interface that has some area and the forces acting over that area are called pressure. Pressure if Force divided by area and the unit of pressure is the Pascal, however 1 pascal is very small at 1N/m^2 or 100grams spread over 1million sq millimeters = 0.00001 grams / mm^2. So it is common to use kilopascals (1000 pascals) or KPa as the standard unit of pressure. Go here for a PPT presentation on CoF Vs CoP
7 comments
Read more
Presentation on analysis and interpretation of characterisation of pressure mat data This is an embedded Microsoft Office presentation, powered by Office Online . or go here   pressure mat systems
Post a Comment
Read more